Georgia Fiero Club Forum
All Things Fiero => The Market => Topic started by: 4oh4 on September 08, 2018, 02:16:55 pm
-
I am parting out my 88GT and have finally got to getting the cradle separated and motor/trans pulled off. It does have some basic surface rust, but a wire brush and some paint and it would be just fine.
Comes with all motor/trans brackets (auto, 2.8), axle shafts, and a set of struts (pretty much everything seen pictured). It does not come with calipers, but does still have the individual e-brake cables attached. If I don't get any interest soon on here I will be posting it on Pennocks, but I would rather see it go to a local person first.
Pictures can be found at https://imgur.com/a/yFjVNm7 (Too large to embed here)
I am also open to trades, and not even necessarily Fiero related either.
Marietta/Roswell GA.
-
Did the Fiero's frame rust out?
-
Including all the links, knuckles, and struts, that's really not a bad price. That's assuming that the rust is, indeed, just surface rust.
(I still think Charlie ought to swap an 88 cradle into his 86 SE, but that's just me. :D )
Regardless, good luck!
-
I think so, too but I KNOW i don't have the money to do it. :'(
-
I can get some closer pictures if need be. The frame of the car didn't rust out, I bought it for the interior and other hard to find tiny parts for the 86.
-
If you are parting the car out, I'd like to buy the bolt that holds the AC lines together, under the air filter housing.
-
I think so, too but I KNOW i don't have the money to do it. :'(
You could at least reuse your same struts.