Georgia Fiero Club Forum
All Things Fiero => The Market => Topic started by: Sandman87 on September 08, 2019, 07:51:24 am
-
i broke the inlet on the fuel pressure regulator cap {black circle on fuel rail} if any one has one in the market for one .
-
The vacuum port?
-
yes! i was hoping to do first start today but ima need that
-
If you're a paid member, there may be one in the parts barn.
-
I'll pull one off one of my fuel rails. Check your PM's.
-
could i use the one off of the camoro fuel rail that i still have ???!!!
-
That should work.
-
I have the fuel rail off my parts car... somewhere.
-
We talked this afternoon. He's using the cap from the Camaro rail and saving the regulator for possible future needs.
-
Thank you everyone for the quick responses. I talked to fiero fool and yes the Camaro fuel pressure regulator cap worked perfectly. Unfortunately,I had a little slip with the ratchet while working on the car shortly after talking to fierofool while working on some brackets on the bottom side the engine " damn AC bracket" and upon tighten in a bolt I slipped off the ratchet and busted my hand open pretty good which required a doctor's visit some shots and sutures .my hand is super swollen and I am unable to use my hand to the caliper required to work on cars at the moment. But I'm sure I will make a full recovery no worries and when I do I hope to finish up the work on it and have the fiero running soon. Again thank you all for your help.
-
Ouchie! Hope it heals soon.