Georgia Fiero Club Forum

All Things Fiero => Tech Tips, Tech Questions => Topic started by: Fierofool on December 31, 2019, 12:57:33 pm

Title: Installing New GT Taillight Lenses
Post by: Fierofool on December 31, 2019, 12:57:33 pm

Most of the butyl tapes I have found are too wide and must be hand-rolled to reduce its size. The windshield setting tape I have on hand is 3/8 inch square.

This material is what's used for attaching the door moisture barriers. It's already in a 1/4 inch round roll and is narrower than the channel on the tail light housing. One roll should be able to do both tail lights.

https://www.amazon.com/dp/B...?tag=viglink20337-20 3M 08620 Window-Weld 1/4"

I ordered it through NAPA and it was priced at $12.20 for 1 roll, including Georgia sales tax.  I went down to pick it up and they said that NAPA wouldn't let them sell one roll.  I had to buy the whole case at $256. 

I drove over to O'Rielly's and asked if they could get it.  Their price was $25+ per roll but they did sell it by the roll.  Showed them my NAPA receipt and they price-matched NAPA. 

Title: Re: Installing New GT Taillight Lenses
Post by: GTRS Fiero on December 31, 2019, 02:53:53 pm

I take it you received your lenses.  Have the masking issues been addressed?