Home
About Us
Calendar
Fiero Documents
Merchandise
Tips
Links
Members
Message Board
Other Fiero Clubs
VIN Decoder
Speed Calculator
GFC Facebook Page
 

Author Topic: TCC Switch Replacement  (Read 15100 times)

0 Members and 1 Guest are viewing this topic.

Fierofool

  • Global Moderator
  • *****
  • Posts: 10,709
    • View Profile
    • Georgia Fiero Club
TCC Switch Replacement
« on: August 29, 2017, 09:06:31 pm »
I picked up a customer's car today and while bringing it back, I found that the trans wasn't going into overdrive.  Verified that the TCC switch had been unplugged by the previous owner that she bought the car from in Texas.  She's been driving it this way for a year.

Is there anyone that would be willing to replace the TCC switch over the labor day weekend?  As most of you know, I can't physically do it, and if it's raining, I have no place indoors.  This isn't a freebie job.  She will pay to have it done. 
There are three kinds of men:

1.    The ones that learn by reading.
2.    The few who learn by observation.
3.    The rest of them have to pee on the electric fence and find out for themselves.    Will Rogers

Fierofool

  • Global Moderator
  • *****
  • Posts: 10,709
    • View Profile
    • Georgia Fiero Club
Re: TCC Switch Replacement
« Reply #1 on: September 03, 2017, 09:59:40 pm »
Switch is due at Transfer on Tuesday.  GTXvette has offered to install it.  Plugged in the old one and it worked..  for about 12 miles then it locked up again.  Stranded at a traffic light.

A question about the fluid.  If its foamy on the stick is it too low or too full?
There are three kinds of men:

1.    The ones that learn by reading.
2.    The few who learn by observation.
3.    The rest of them have to pee on the electric fence and find out for themselves.    Will Rogers

Roger

  • Paid Members
  • *****
  • Posts: 847
  • If it’s the thought that counts, think money.
    • View Profile
Re: TCC Switch Replacement
« Reply #2 on: September 03, 2017, 11:31:46 pm »
Marks on the stick should tell you if it's too low or too full. If it's red and smells 'sweet' you're ok but I'd change it anyway. Really pink and foamy may indicate a leak in the cooler that's inside the radiator. Best to change the fluid anyway after 30K miles.
You can't fix stupid but, you can adjust it with a 2x4.

Fierofool

  • Global Moderator
  • *****
  • Posts: 10,709
    • View Profile
    • Georgia Fiero Club
Re: TCC Switch Replacement
« Reply #3 on: September 06, 2017, 10:06:06 pm »
This has been a real ordeal.  But first to the foamy trans fluid. 

When I replaced the TCC case connector on Ray's car, I had to remove the side cover to get some of the broken retainers out.  There was very little fluid that came out.  Mostly what was sitting on the bottom lip of the cover and a little puddled in the bottom of the valve body housing.  Today when we took off the cover on this car, there was lots of fluid came out.  I believe the foamy problem might have been that the transmission was over full. 

Now, for the ordeal part.  I ordered the switch and gasket from Transtar on Goshen Springs Road in Norcross.  A major supplier of transmission parts.  I went down on the day it was to arrive, and they had sent it to a location near Auburn, Alabama.  So, we reordered and it was to be in on Thursday. 

Thursday, I made another trip to Transtar only to be told that he forgot to order it.  So, it was ordered again and because of the labor day weekend, would not arrive until Tuesday.  This time I called before making the trip.  Warehouse sales counter goes to voice mail.  Left a message.  Called two more times during the day, leaving a message.  No return call. 

So I called an ACDelco dealer in Winder.  The switch and gasket are no longer uavailable, says they.  Called Sosebee's ACDelco Auto Parts in Lawrenceville.  They said it would be in this morning by 10:30, but they didn't have the gasket.  Called Nash Chevrolet in Lawrenceville.  They could get the gasket by next week but Maxey Price in Loganville had 4. 

This morning, I hotfooted it down to Loganville and picked up the gasket, then back up to Lawrenceville to Sosebee's.  Arrived at 10:35.  No part was showing for me.  He asked me again what name it was under and when I told him, a guy that had just brought in a push cart full of parts and was entering them into the computer says "Here it is" scanned it in and handed it over to the sales clerk.  I'm a happy camper, now.

A warning---This isn't a one person job.  There are times you need to be above and underneath at the same time. 

TCC Case Connector--Transtar invoice part number is 74444A with another number of 25A-103. It's called a Connector, Part Nr.700-R4 Case G.  There's a photo of it in Tech Advise in my article on replacing the switch or connector.  Gotta do some rewriting of that, after what we learned on this job. 
TCC lockup switch--ACDelco part number 8689901 cross references to Transtar 64425B.
GM Valve body cover gasket--8643573 cross references to Transtar 64301F.  F is for the thicker fiber gasket, not the cork one. 
I noticed that the Transtar gasket was thicker than the GM gasket.  That might be beneficial. 

Due to the weather, we got a late start.  John (GTXvette) came over and got to work on it.  Not a great deal of problem getting everything apart.  Not a lot of problem getting the new switch mounted back into the transmission.  The thing that took the longest was getting the switch plugged back into the TCC Case Connector.  That's the plastic piece that the outside harness plugs into and the switch plugs into inside the transmission.  Just no working room.

We finally decided to detach the TVI cable where it's bolted to the transmission.  This was done per directions in a how-to article on Pennocks by Chuck Kichline.  Don't remember his username at the moment.  Unbolting the TVI cable and pulling on it moves a bracket out of the way to make it easy to plug the switch into the back of the connector. 

Our experience after more than an hour of trying is that if you plug it in, you're lucky.  After a lot of trying and failing, I thought John was going to go home for the day.  We decided that we would take the TCC Case Connector out, pass the switch wires through the case so we could plug it in with the connector and harness end outside the case.  With a little work, we had to plug the TCC harness back into the outside of the case connector to have something to grip while I pulled on it, John worked his magic on the retainer tabs inside the case.  It popped right out. 

We found that working in the blind we had bent the terminals of the case connector where the switch plugs on.  Straightened them, plugged the switch in, inserted the case connector back into the case, and in probably an hour's time, it was buttoned back up. 

I suggest that if you ever have to replace your TCC switch, that you plan it well in advance.  Get the OEM switch so you don't have to cut and splice wires.  It will be hard to do in that confined space, and you risk them shorting or coming loose later.  The aftermarket switches also have two mounting points.  The OEM only has one and its held on by a #30 Torx head bolt.  Get the gasket and get the TCC Case Connector.  That way you can break the case connector to get it out if you need, then install the new one.  All these are available at Transtar.  But like I said, plan the job in advance.  Their prices are cheaper than anywhere else. 

John, I thank you very much for taking on this job.  I'm sorry for the difficulties, but it turned out to be a good learning experience.  You're a real champ.
« Last Edit: September 07, 2017, 01:59:13 pm by Fierofool »
There are three kinds of men:

1.    The ones that learn by reading.
2.    The few who learn by observation.
3.    The rest of them have to pee on the electric fence and find out for themselves.    Will Rogers

GTRS Fiero

  • Hero Member
  • *****
  • Posts: 12,510
  • It is what it is.
    • View Profile
Re: TCC Switch Replacement
« Reply #4 on: September 07, 2017, 06:56:47 am »
Situations like this are probably the only benefit to having skinny arms and hands.

GTXVette

  • Hero Member
  • *****
  • Posts: 519
    • View Profile
Re: TCC Switch Replacement
« Reply #5 on: September 07, 2017, 09:08:04 am »
   
   Thank you for the Kind words,        Gtrs, boy howdy skinny fingers and arms would have been Nice but I have neither, I'm Only 130 lbs. But Have Fat Fingers.      So when I reached in to remove my first Bolts on the side cover I Said,  Charlie do you have a catch Bucket ?   No worries he say's only a few drips will come out .
  about a quart Later as I am trying to shove the cover back on, we decide that may be about all, not expecting that, we had no oil absorbent but he did have a moving blanket to put down,  I proceeded with my task while Charlie went to the Store for Kitty litter. I did wear a long Sleeve shirt with a T- under it, 
both shirts and Blanket were soaked, I wear my hair kinda long and between Charlie Standing on it and Laying in soaked Kitty litter, I need a bath.

 All in all not the worst job but a suggestion,   Next Time,  I think I will remove the Cradle bolts on the driver side to drop it about 6-8" just to clear the body frame to acess the cover, the rest was easy except trying to plug the connector back in and removing the case connector made it Mo' better, you may SEE it easier with the Cradle Lowered as we were using a Mirror to see the Connnector.

So the Late Start made for a long Day And I managed to turn a 3 Hr. Job into a Six Hr. Ordeal, Next one will be easy.

  It was Great Getting to know Charlie and Meeting Mel. I like them, Very Normal Folks .  John aka GTXVette

Raydar

  • Paid Members
  • *****
  • Posts: 3,016
    • View Profile
Re: TCC Switch Replacement
« Reply #6 on: September 07, 2017, 11:23:26 am »
...Not a great deal of problem getting everything apart.  Not a lot of problem getting the new switch mounted back into the transmission.  The thing that took the longest was getting the switch plugged back into the TCC Case Connector. 
...

Yup. Thought that was what I remembered, from when I did mine.
Mine was of a PITA, and I had the cradle out of the car.
Glad y'all got 'er done.
...

Fierofool

  • Global Moderator
  • *****
  • Posts: 10,709
    • View Profile
    • Georgia Fiero Club
Re: TCC Switch Replacement
« Reply #7 on: September 07, 2017, 01:53:20 pm »
I just delivered the car.  The lady was about to leave in her Jeep Patriot when I got there.  She got everything out, put it in the Fiero and said she was driving it. 

There are three kinds of men:

1.    The ones that learn by reading.
2.    The few who learn by observation.
3.    The rest of them have to pee on the electric fence and find out for themselves.    Will Rogers

GTRS Fiero

  • Hero Member
  • *****
  • Posts: 12,510
  • It is what it is.
    • View Profile
Re: TCC Switch Replacement
« Reply #8 on: September 07, 2017, 04:45:45 pm »
Um, how did you deliver her Fiero?  Trailer, or 2nd driver?

Fierofool

  • Global Moderator
  • *****
  • Posts: 10,709
    • View Profile
    • Georgia Fiero Club
Re: TCC Switch Replacement
« Reply #9 on: September 07, 2017, 04:56:27 pm »
I drove my 87GT up there and left it when I picked up her car to repair her headlight motor.  On the way back with her car is when I discovered the problem with the TCC switch. 
There are three kinds of men:

1.    The ones that learn by reading.
2.    The few who learn by observation.
3.    The rest of them have to pee on the electric fence and find out for themselves.    Will Rogers

oldone

  • Hero Member
  • *****
  • Posts: 630
    • View Profile
Re: TCC Switch Replacement
« Reply #10 on: September 07, 2017, 05:17:21 pm »
Charlie did the shift clip get there?
the world is a sh t sandwich and everyday is another little bite

Fierofool

  • Global Moderator
  • *****
  • Posts: 10,709
    • View Profile
    • Georgia Fiero Club
Re: TCC Switch Replacement
« Reply #11 on: September 07, 2017, 07:17:36 pm »
Yes it did.  I had replied in my want ad.  In my rush today to get the splash guards and fenderwell liner installed and get the car back to her, I forgot to install it.  I'll have to make another trip up there after RFTH, but she needs the left headlight motor rebuilt and another coolant recovery tank installed. 
« Last Edit: September 07, 2017, 07:19:50 pm by Fierofool »
There are three kinds of men:

1.    The ones that learn by reading.
2.    The few who learn by observation.
3.    The rest of them have to pee on the electric fence and find out for themselves.    Will Rogers